Page 1 of 1
Breaking lines into parts
Posted: Sun Jul 24, 2016 11:01 pm
by asbic consultants ltd
Hi
Is there any way that I can split a line into two or more parts?
I'm using the perimeter tool and have decided I want a different line style for part of it. OK I could redo it in two parts but it would be easier if I could click on the line and presto it becomes two lines
Asking too much?!
regards
Bruce
Re: Breaking lines into parts
Posted: Mon Jul 25, 2016 12:28 am
by Will - Tracker Supp
Hi Bruce,
Thanks for the email - I'm afraid that there isn't any way to split annotations in this manner.
Thanks,
Re: Breaking lines into parts
Posted: Fri May 10, 2019 8:43 am
by MJN
I've been pining for this feature too...
Is it a permanent, hardwired impossibility?
Re: Breaking lines into parts
Posted: Fri May 10, 2019 10:09 am
by Will - Tracker Supp
Hi MJN,
I'm afraid so - There is no provision in the PDF Specification that would allow for this, as far as I'm aware.
Cheers,
Re: Breaking lines into parts
Posted: Sun May 12, 2019 4:48 pm
by David.P
Hi all,
I would draw the polygon, then copy/paste a copy of it (it should be pasted exactly "into place"), and then change color and delete unwanted parts of the copy.
Cheers
David
Re: Breaking lines into parts
Posted: Sun May 12, 2019 6:00 pm
by Will - Tracker Supp
Thanks David
Re: Breaking lines into parts
Posted: Mon May 13, 2019 6:09 am
by MJN
Thanks for the valiant try David!
I do quantity takeoffs for precast concrete and I use the lines for calculating the quantity, so it would not be a good idea to have lines on top of each other.
Besides, I'm usually having to change many small sections to other colors (typically to change the strength of the concrete)…
But thanks again, guess I'll still have to do some real work for a living
Re: Breaking lines into parts
Posted: Mon May 13, 2019 9:03 am
by Will - Tracker Supp