Non-blocking mode greyed out?

giacomo.ciani · Post by **giacomo.ciani** » Thu Jul 31, 2014 2:41 pm

Hi all,

I'm a very satisfied "viewer" user, and I just installed to "editor". While browsing the settings, I found the option "non-blocking mode for source file", that immediately caught my attention as it would be very useful (when you need to generate a pdf over and over again to check it, it's annoying to have the process fail if you forget to close it in the viewer).

However, said option is grayed out (and disabled), so there is no way of enabling it. Is it exclusive of the pro version? There is no explanation about why it is unavailable...

Thanks

Giacomo

P.S. I found the same question asked in this post, but it was not answered

Post by **Will - Tracker Supp** » Thu Jul 31, 2014 9:59 pm

Hi Giacomo,

Thanks for the post - this checkbox is currently a placeholder and was removed for build 309, to maximize space until its implementation.

Cheers,

giacomo.ciani · Post by **giacomo.ciani** » Thu Jul 31, 2014 11:24 pm

I see. I'm looking forward to see this implemented...

Thank for the prompt answer, and keep up to great job you guys are doing!

Giacomo

Post by **Will - Tracker Supp** » Fri Aug 01, 2014 2:36 pm

Not a problem!

Thanks for the kind words too

Non-blocking mode greyed out?

Non-blocking mode greyed out?

Re: Non-blocking mode greyed out?

Re: Non-blocking mode greyed out?

Re: Non-blocking mode greyed out?