Page Range in Print Dialog

[t-arn]

First of all, I'd like to congratulate you for this terrific product!

But I don't think it's a good idea to remember the Page Range in the Print Dialog:
I print a document's current page only, and the next time I open and use the Viewer I would expect it to set the default Page Range to "All", but it is still on "Current Page". I always stumble over this behavior which differs from all other programs.

Just something to think about...

Best regards
Tom

[cadcoke3]

Thanks for mentioning that. I had a problem the other day when a customer didn't get all of a drawing set... just one page. I had blamed myself for the error (and of course looked bad), but now I see that it was probably the issue you mentioned.

Joe Dunfee